Hdd Low Level Format; Save & Exit Setup; Exit Without Saving - EPOX EP-58MVP3C-M Manual

3-20 CHAPTER 3
Note:
To support LBA or LARGE mode of HDDs, there must be some softwares involved. All
softwares are located in the Award HDD Service Routine (1NT 13h). It may fail to access
a HDD with LBA (LARGE) mode selected if you are running under on Operating
System which replaces the whole 1NT 13h. UNIX operating systems do not support
either LBA or LARGE and must utilize the Standard mode. UNIX can support drives
larger than 528MB.

3-10 HDD LOW LEVEL FORMAT

Interleave
Select the interleave number of the hard disk drive that you wish
to perform a low
Check the documentation that
interleave number, or select 0 for automatic
Auto scan bad track
This allows the utility to scan first then format by each track.
Start
Press<Y>to start low level format.
3-11 SAVE & EXIT SETUP
The "SAVE & EXIT SETUP" option will bring you back to boot up procedure
with all the changes you just recorded in the CMOS RAM.

3-12 EXIT WITHOUT SAVING

The "EXIT WITHOUT SAVING" option will bring you back to normal boot
up procedure without saving any data into CMOS RAM. All old data in the
CMOS will not be destroyed.
level format on. You may select from 1 to 8.
came with the drive for the correct
d e t e c t i o n .