Hdd Low Level Format; Save & Exit Setup; Exit Without Saving - EPOX EP-5BTXA-E User Manual

Note:
To support LBA or LARGE mode of HDDs, there must be some softwares involved. All
these softwares are located in the Award HDD Service Routine (1NT 13h). It may be failed
to access a HDD with LBA (LARGE) mode selected if you are running undera Operating
System which replaces the whole 1NT 13h. UNIX operating systems do not support either
LBA or LARGE and must utilize the Standard mode. However UNIX can support drives
larger than 528MB.

3-10 HDD Low Level Format

Interleave
Select the interleave number of the hard disk drive you wish to perform low
level format. You may select from 1 to 8. Check the documentation that
came with the drive for the correct interleave number, or select 0 for utility
automatic detection.
Auto scan bad track
This allows the utility to scan first then format by each track.
Start
Press<Y>to start low level format.
3-11 Save & Exit Setup
The "SAVE & EXIT SETUP" option will bring you back to boot up procedure
with all the changes you just made which are recorded in the CMOS RAM.

3-12 Exit Without Saving

The "EXIT WITHOUT SAVING" option will bring you back to normal boot up
procedure without saving any data into CMOS RAM. All of the old data in the
CMOS will not be upduted.
AWARD BIOS 3-19