Integrated Peripherals - EPOX EP-58MVP3C-M Manual

3-14 CHAPTER 3

3-6 INTEGRATED PERIPHERALS

Onboard Primary PCI IDE
Onboard Secondary PCI IDE : Enabled
IDE Prefetch Mode
IDE HDD Block Mode
IDE primary Master PIO
IDE Primary Slave PIO
IDE Secondary Master PIO
IDE Secondary Slave PIO
IDE Primary Master UDMA : Auto
IDE Primary Slave UDMA
IDE Secondary Master UDMA
IDE Secondary Slave UDMA : Auto
PCI IDE Secondary Channel : Enabled
Onboard FDD Controller
Onboard Serial Port 1
Onboard Serial Port 2
UART 2 Mode
Note: If you don't use the Onboard IDE connector, but use On-card
(PCI or ISA card) IDE connector. You have to set Onboard Primary
PCI IDE: Disabled and Onboard Secondary PCI IDE: Disabled
from CHIPSET FEATURES SETUP UTILITY.
The Onboard PCI IDE cable should be
18 inches (45 cm.).
IDE HDD Block Mode: The default value is Enabled.
Enabled : Enabled IDE HDD Block Mode. The HDD transfer rate is better than
Disable.
Disabled: Disable IDE HDD Block Mode.
PCI Slot IDE 2nd Channel: The default value is Enabled.
Enabled : Enable secondary IDE port and BIOS will assign IRQ15 for this port.
Disabled : Disable secondary IDE port and IRQ15 is available for other device.
Onboard Primary PCI IDE: The default value is Enabled.
Enabled : Enable Onboard 1st channel IDE port.
Disabled : Disable Onboard 1st channel IDE port. When use On-card (PCI or ISA
card) IDE connector.
Onboard Secondary PCI IDE: The default value is Enabled.
Enabled : Enable Onboard 2nd channel IDE port.
Disabled : Disable Onboard 2nd channel IDE port When use On-card (PCI or ISA
card) IDE connector.
ROM PCI/ISA BIOS(2A5LEPA9)
INTEGRATED PERIPHERALS
WARD SOFTWARE, INC.
: Enabled Onboard Parallel Port
Onboard Parallel Mode
: Enabled ECP Mode Use DMA
: Enabled Parallel Port EPP Type
: Auto OnChip USB
: Auto
: Auto
: Auto
: Auto
: Auto
ESC : Quit
: Enabled
F1 : Help
: Auto
F5 : No Change
: Auto
F7
: Standard
: 378/IRQ7
: ECP / EPP
: 3
: Disabled
PU/PD/+/- : Modify
(Shift) F2 : Color
: Load Setup Defaults
equal to or less than
: EPP1.9
: Select Item