Integrated Peripherals - EPOX P55-KV Manual

3-12 CHAPTER 3

3-6 INTEGRATED PERIPHERALS

Onboard Primary PCI IDE
Onboard Secondary PCI IDE
IDE Prefetch Mode
IDE primary Master PIO
IDE Primary Slave PIO
IDE Secondary Master PIO
IDE Secondary Slave PIO
Onboard FDC Controller
Onboard UART 1
Onboard UART 2
UART 2 Mode
Onboard Parallel Port
Onboard Parallel Mode
ECP Mode Use DMA
Parallel Port EPP Type
If you don't use the Onboard IDE connector, then use On-card
Note:
(PCI or ISA card) IDE connector. You have to set Onboard Primary
PCI IDE: Disabled and Onboard Secondary PCI IDE: Disabled
from CHIPSET FEATURES SETUP UTILITY.
The Onboard PCI IDE cable should be
18 inches (45 cm.).
IDE HDD Block Mode: The default value is Enabled.
Enabled : Enabled IDE HDD Block Mode. The HDD transfer rate is better than
Disable.
Disabled: Disable IDE HDD Block Mode.
PCI Slot IDE 2nd Channel: The default value is Enabled.
Enabled : Enable secondary IDE port and BIOS will assign IRQ15 for this port.
Disabled : Disable secondary IDE port and IRQ15 is available for other device.
Onboard Primary PCI IDE: The default value is Enabled.
Enabled : Enable Onboard 1st channel IDE port.
Disabled : Disable Onboard 1st channel IDE port. When use On-card (PCI or ISA
card) IDE connector.
Onboard Secondary PCI IDE: The default value is Enabled.
Enabled : Enable Onboard 2nd channel IDE port.
Disabled : Disable Onboard 2nd channel IDE port When use On-card (PCI or ISA
card) IDE connector.
ROM PCI/ISA BIOS(2A5LDPAD)
INTEGRATED PERIPHERALS
WARD SOFTWARE, INC.
: Enabled
: Enabled
: Enabled
: Auto
: Auto
: Auto
: Auto
: Enabled
: 3F8/IRQ4
: 2F8/IRQ3
: Standard
: 378/IRQ7
ESC : Quit
: ECP / EPP
F1 : Help
: 3
F5 : No Change
: EPP1.9
F7 : Load Setup Defaults
equal to or less than
: Select Item
PU/PD/+/- : Modify
(Shift) F2 : Color