Turning Off The Appliance Server; Standby Mode - IBM eServer 130 xSeries User Reference Manual

Turning off the appliance server

Turning off the appliance server refers to the act of disconnecting the appliance server
from the power source.
Statement 5
CAUTION:
The power control button on the device and the power switch on the power
supply do not turn off the electrical current supplied to the device. The device
also might have more than one power cord. To remove all electrical current
from the device, ensure that all power cords are disconnected from the power
source.
Complete the following steps to turn off the appliance server:
1. Use UM Services to remotely shut down your appliance server. See "xSeries 130
2. Press the power-control button on the front of the appliance server. This will put
3. Disconnect the appliance server from the power source.

Standby mode

Standby mode puts the appliance server into a wait state. When in a wait state, the
appliance server is not running the operating system, and all core logic is shut down.
Complete the following steps to put the appliance server into the standby mode:
1. Use UM Services to remotely shut down your appliance server. See "xSeries 130
2. Press the power-control button on the front of the appliance server.
12
IBM xSeries 130: User's Reference
Configuration Tools" on page 17 for more information.
the appliance server into standby mode.
Note: After you turn off the appliance server, wait at least 5 seconds before you
turn on the appliance server again.
Configuration Tools" on page 17 for more information.