Software: Repetier Host - Mass Portal Pharaoh ED User Manual

Control: Holding the
control button, you
can rotate the view
with the left mouse
button.
Shift: Holding shift
button you can move
the view point with
the left mouse button.
Right Mouse Button:
Move the object by
holding the right
mouse button.
Mouse Wheel: Zoom
view
Emergency Stop –
use this button to
immediately stop
whatever printer
is doing. Useful if
you notice unusual,
erratic or incorrect
movements of the
printing head.
30
MP Delta Manual ENG +.indd 30

Software: Repetier Host

Good all in-one solution
1. Create a 3D model or get it from the internet.
2. Arrange one or more models on a virtual print plate.
3. Slice the the models into thin slices and compute a path for
printer head. This is done by a slicing software, which converts
the model into g-code, the language your printer speaks.
4. Check the created g-code for errors and printability.
5. Send the g-code to your printer or copy the code to a SD card,
which you can insert into your printer.
Control your printer
When you open the software you are able to connect to your
3D printer, load your desired model and also control your printer
from it and of course start the printing job.
1) Load file – allows to load 3D object files in the following
formats: *.gcode, *.gco, *.stl; *.obj, *.3ds;
2) Save Job – by pressing this button to save G-Code:
3) Run (Pause) job – you can start the printing by pressing this
button. If the printing has already been started, it will change to
Pause job. You can pause printing if you need to change filament
and even move the head around. It will resume where you left
when clicking on Continue Printing;
4) Kill job – completely stops the printing and the head returns to
home position;
15/04/15 17:03