Mass Portal Pharaoh ED User Manual page 20

20
MP Delta Manual ENG +.indd 20
USING THE PRINTER CONTROL PANEL — CONTINUED
Utilities menu
Lists commands for various maintenance tasks.
>Home All
Change Filament
Release Printhead
Extrude
Cooldown
Turn Fan Off
Bed LED: 25%
Home All — Moves the printhead to it's default position at the top
of the printing chamber.
Change Filament — Pulls out the filament. Printhead must be
heated for this command to work.
Release Printhead — Disables the stepper motors that hold the
printhead in place, so you can move it around with your hads —
useful for printer maintenance.
Extrude — Extrudes the filament. Useful to check the flow and
loading of the filament before starting a print. The printhead
must be heated to the temperature neccessary for the particular
filament for this command to work. To extrude, press and hold the
Down arrow button while in this screen. Also shows the amount
of filament printed.
E: 0.00 mm
1 click = 1 mm
E:240.0/240°C-> 0.00
100.0 m printed
Cooldown — Turns off heating for both printhead and printbed.
Bed LED — set the brightness of LED temperature indicator lights
below the printbed. Set it to 0 to turn the lights off completely.
->
15/04/15 17:03