My First Print - Mass Portal Pharaoh ED User Manual

My First Print

The printer comes with a SD card already inserted, so you can
print a test print without connecting computer.
1. Turn on the printer
The power switch is on the back of the printer. Make sure there
are no objects on the printbed. You may keep the doors closed
or open for the first test print.
2. Place the sample filament spool on the holder
Unbox the bundled filament and place the spool on the holder on
the backside of the printer.
3. Insert the filament into the extruder
Firmly push the filament release lever on the back side of the
printer and insert filament into the filament hole besides the
release lever. Push in the filament untill it stops. You should see
filament moving through the bowden tube.
4. Select MyFirstPrint from Printing Menu
Use the navigation buttons on the printer:
1. Press > (Right arrow button)
2. Select Mount SD Card (using up / down arrow buttons) and
press OK button (if not alread wwy mounted)
3. Select Print File and Press OK button
4. Select Samples Folder and press OK button
5. Select MyFirstPrint and press OK button — then wait
5. Wait until the printhead and heated bed warm up
The printer will start printing only when printbed and printhead
are heated up to the neccessary temperatures; both printbed and
printhead will be hot when printing. Do NOT touch the moving
parts while printing. The LED lights below the printbed will turn
yellow and gradually red with temperature increase.
6. Watch it print
7. Let it cool down for a while after printing
Wait untill the lights below printbed are yellow or white.
You can also see the temperatures on the LCD screen.
You can remove the filament while the printhead is still hot.
8. Remove the print from the print bed
Use the supplied tool to gently peel off the object.
MP Delta Manual ENG +.indd 11
INFO Instert filament
into this hole on the
back side of the
printer. You need to
firmly press and hold
the filament release
lever to do so.
TIP You should see
the filament moving
down thru the
bowden tube when
insterting it. Firmly
push the filmanent in
untill it stops.
TIP To remove or
change the filament,
the printhead must
be heated or still hot
after printing.
TIP You don't need
to remove the
filament after each
print.
11
15/04/15 17:03