Printer Setup - Mass Portal Pharaoh ED User Manual

INFO The filament
spool holder is
designed to be
compatible with
different form
factor filament
spools from various
manufacturers.
INFO The power
switch, power cord
connector and fuse
panel.
10
MP Delta Manual ENG +.indd 10

Printer Setup

1. Unbox the printer
Be careful, the printer is not very light — 16,5kg.
Open the box — there's a side door.
Pull the printer out of the box carefully, grabbing at the sides.
It's easier ir somebody can help holding the box.
Take the printer out of the plastic bag.
Place the printer on it's box or other stable surface.
Open the front door and take out the bundled filament box and
the accessories box.
You can move the printhead up, gently pushing it with hands.
Remove the protective foam plate from the printhead.
2. Let the printer warm up to room temperature
Unbox and inspect everytnig — the power cord, filment spool
holder, sample filament roll.
This is important — especially in cold weather. In winter, it may
take a long time, don't rush it.
4. Attach the filament spool holder
It's in the cardboard box in the printer.
It simply slides in to the filament spoll holder on the back side of
the printer.
5. Browse the manual and read the Getting Started
chapter
If you have not read it yet, do it now.
6. Connect the power cord and plug it in
Now the printer is ready to go.
The printer can print g-code files form the SD Card now, in
standalone mode. Setting up software on the computer and
connecting the printer to computer are discussed later in the
manual.
15/04/15 17:03