Mass Portal Pharaoh ED User Manual page 19

USING THE PRINTER CONTROL PANEL — CONTINUED
Control menu
Lists commands for to adjusting the printing parameters while
printing.
The > at the
left indicates
selected menu
item. Press OK
button or > (right
arrow button) to
execute it
Preheat menu
Lists commands for preheating the printer to print with the
selected kind of filament. The temperatures can be adjusted
later in the control menu or you can select custom temperatures
for your filament. When selected, printer will start heating up and
display a corresponding stats message. You will also hear the
head radiator fan turn on. Cooldown turs off the heating for both
the printhead and the printbed.
Custome Preheat menu
Select the manufacturer suggested temperatures for your
filament. Bed heating is optional, you can preheat the printhead
only.
MP Delta Manual ENG +.indd 19
>Speedrate : 100%
Flowrate : 100%
Fan Speed :
Head Temp : 210°C
Bed Temp : 210°C
Change Filament
>Preheat PLA
Preheat ABS/HIPS
Preheat PET/XT
Preheat Custom
Cooldown
Head Temp : 240°C
Bed Temp : 120°C
TIP Fan speed
percentage is
estimated, and fans
will not work all
the way down to 0
percent.
0%
TIP Printhead must
be heated to remove
/ change filament.
You need to heat up
to the corresponding
temperature to
remove a particuar
kind of filament.
Example: If you have
been printing PET
and need to remove
it to cahnge to PLA,
first heat up for the
PET (higher temp)
->
to remove it, then
change to the lower
printing temperature
for the PLA. You
usually do not need
to fully reach the
target temperature to
remove the filament.
19
15/04/15 17:03