Mass Portal Pharaoh ED User Manual page 23

USING THE PRINTER CONTROL PANEL — CONTINUED
Calibration menu
Use the calibration command if the first layer is not printing
correctly. Rememeber to check the Bed Coating settings.
While performing the calibration, status message will be
displayed, and a success confirmation when the calibration
process is finished.See more in the Automati Calibration chapter.
MP Delta Manual ENG +.indd 23
>Calibrate Printbed
Reset Calibration
Calibrating...
Verifying...
The printbed has
been claibrated
23
15/04/15 17:03