Mass Portal Pharaoh ED User Manual page 45

Filament breaks and goes after filament drive gear.
There is sometimes a case when filament breaks near feed hole
and if the printer is still printing filament end goes after drive gear
in bowden tube then it is impossible to push it out.
To remove filament from bowden tube heat up printhead and
push with two fingers bowden tube's mount button, then remove
tube firstly pushing it in then out. The same bowden tube mount
is also on other tube's end.
Press the grey
coupling to release
filament tube
MP Delta Manual ENG +.indd 45
WARNING Do not
use force. If bowden
tube mount button
is pressed the tube
should come out
freely.
45
15/04/15 17:03