Mass Portal Pharaoh ED User Manual page 31

REPETIER-HOST — CONTINUED
Manual control
We offer you to see how the basic commands works in Repetier-
Host software. If you want to advance then visit http://www.
repetier.com/documentation/repetier-host for more detailed
information, tutorials etc. When you turn your printer on, you will
often come to this tab. At the top you see the most important
printer status, so you always know what is happening.
Home position – printer head resets to the home position which
is at the top of the printer. It should always be at Home position
before printing objects. It is not recommended to press it (and
other movement control buttons) under printing;
Movement of X and Y axis – move the printing head to left or
right, front or back;
Z axis movement – use this to move printing head up or down;
Each arrow has 3 or 4 separate blocks which define the amount
in millimeters to move the printing head;
Extrude material – it is recommended to check the flow of
filament (and if it is not clogged) before starting print to get good
adhesion once the printing has started. Heat up the extruder to
at least 170°C before using these buttons. The filament must flow
out evenly, without interruptions to ensure good start of print.
Be careful when removing the extruded test-filament – though it
cools rather quickly, it may still be hot enough to burn skin.
MP Delta Manual ENG +.indd 31
When you hover
over the arrow, you
will see a distance
appear in mm.
You can change
the flow rate, ie
the amount of
the extruded
filament. A higher
valie gives a fatter
printed line.
31
15/04/15 17:03