Mass Portal Pharaoh ED User Manual page 9

SAFETY — CONTINUED
WARM PARTS
The printer frame and outer parts can be warm during operation,
reaching temperatures up to 60°C after extended use.
CLEANING
DO NOT USE FLAMMABLE LIQUIDS TO CLEAN HOT PARTS.
Use dry paper towel to clean print bed and print head. If more
thorough cleaning is needed, the printer must be turned off and
cooled down to room temperature.
MOVING PARTS
The printer mechanics consist of moving parts while operational.
Care must be taken not to touch them during operation.
ELECTRICAL SAFETY
Do not place the printer where it could come in contact with
moisture, especially near open windows. Do not leave the printer
operational unattended. ALWAYS USE GOOD QUALITY CABLE
WITHOUT ANY SIGNS OF DAMAGE OR MALFUNCTION. DO
NOT USE WORN ELECTRICAL SOCKETS.
STATIC ELECTRICITY
Release your body's static electricity by touching a grounded
object before any repair or service operation. POWER MUST BE
OFF AND CABLE UNPLUGGED BEFORE ANY WORK.
TOXIC FUMES
When printing especially with ABS plastic it will lightly emit fumes
and smell, so the premises where the printer is located, must be
well ventilated, but must avoid draught. The odour, toxicity and
intensity of fumes vary with the type of material used.
NOT A TOY FOR CHILDREN
The printer must not be left unattended with children. Children
must always be accompanied and supervised by an adult when
using or abserving this product. Do not leave the printed objects,
waste filament and tools unattended in the reach of small
children to avoid harm and choking hazard. Be careful when
tooling printed objects.
9
MP Delta Manual ENG +.indd 9 15/04/15 17:03