My First Print - Mass Portal Pharaoh XD Series User Manual

INFO Insert filament
into this hole on the
back side of the
printer. You need to
firmly press and hold
the filament release
lever to do so.
TIP You should see
the filament moving
down through the
bowden tube when
inserting it. Firmly
push the filament in
until it stops.
10

My First Print

The printer comes with G-codes already loaded to the internal
memory, so you can print a test print without connecting to a
computer.
1. Prepare the printer
Make sure there are no objects on the print bed. You may keep
the door closed or open for the first test print. As the printer is
shipped with PLA, the side walls should be removed from the
printer.
2. Place the sample filament spool on the holder
a. Unbox the bundled filament
b. Place the spool on the holder on the backside of the printer.
3. Prepare the printbed for printing
-Place the BuildTak on the printbed. Slowly removing the white
film on the bottom and gradually stick the BuildTak on the bed
trying to avoid making air bubbles underneath.
4. Insert the filament into the extruder
a. Firmly push the filament release lever on the back side of the
printer
b. Insert filament into the filament hole besides the release lever.
(You should see filament moving through the bowden tube.)
c. Push in the filament until it stops.
5. Start printing:
a. Load a gcode to the printer using a USB flash drive or IP/TCP
or Wifi connection
b. Select the "Ready to Print" icon on the right side of the screen
c. Select "Object to Print" and find the file you loaded to the
printer
d. The material should be set to PLA and the bed coating set to
BuildTak
e. Select "Start Printing"
f. The printer will heat up and start to print when ready.
TIP It is easier to
insert the filament
if you cut the end
of the filament at
an angle using the
clippers included
with the printer (see
image)