Printer Setup - Mass Portal Pharaoh XD Series User Manual

INFO Filament spool
holder is designed
to be compatible
with different form
factory filament
spools from various
manufacturers.
INFO Power
switch, power cord
connector and fuse
panel.
8

Printer Setup

1. Unbox the printer - using the included instructions
Be careful, the printer is heavy..
2. Let the printer warm up to room temperature
This is important — especially in cold weather. In winter, it may
take a long time, don't rush it.
While waiting unbox and inspect everything — the power cord,
the USB cord, filament spool holder, sample filament roll.
WARNING
If the printer does not warm up to
room temperature before operation there could be
electrical issues due to condensation or there could
be calibration issues
3. Install glass print bed
Align the thumbscrews with the gaps on the glass plate. Gently
push down the bed and turn the glass plate clockwise.
WARNING When installing the
glass bed, for MP20, make sure
that the metal sensor discs for
calibration are in their proper
position. If they are not in the
proper position, the automatic
calibration process will not work
properly. If there are any questions,
please contact support.
4. Attach the filament spool holder
It simply slides in to the filament spool holder bracket on the back
side of the printer.
5. Browse the manual and read the Getting Started
chapter
6. Connect the power cord to the printer, plug it in and
turn on the printer.
The power switch is on the back of the printer.