Pppoe (Username / Password) - D-Link DIR-809 User Manual

Section 3 - Configuration
Choose PPPoE (Point to Point Protocol over Ethernet) if your ISP uses a PPPoE connection. Your ISP will provide you with a
username and password. This option is typically used for DSL services. Make sure to remove your PPPoE software from your
computer. The software is no longer needed and will not work through a router.
Select PPPoE (Username/Password) from the drop-down menu.
My Internet
Connection:
Address
Here the user can specify whether this Internet connection requires the
use of a Dynamic or Static IP address. PPPoE usually requires a Dynamic
Mode:
IP configuration.
Username: Enter the PPPoE account user name used here. This information is given
by the ISP.
Password:
Enter the PPPoE account password used here. This information is given by
the ISP.
Confirm
Re-enter the PPPoE account password used here.
Password:
Service This optional field enables the user to enter a service name to identify this
Name:
Internet connection here.
IP Address: Enter the PPPoE IP address used here. This option is only available if Static
IP is selected.
MAC The default MAC Address is set to the Internet port's physical interface
Address: MAC address on the Broadband Router. It is not recommended that you
change the default MAC address unless required by your ISP. You can use
the Copy Your PC's MAC Address button to replace the Internet port's
MAC address with the MAC address of your Ethernet card.
D-Link DIR-809 User Manual

PPPoE (Username / Password)

20