Pppoe (Username/Password) - D-Link DIR-860L User Manual

Section 3 - Configuration
Choose PPPoE (Point to Point Protocol over Ethernet) if your ISP uses a PPPoE connection. Your ISP will provide you with a username and password.
This option is typically used for DSL services. Make sure to remove any PPPoE software from your computer. The software is not needed and will
not work through a router.
My Internet Select PPPoE.(Username/Password) from the drop-down menu.
Connection:
Address Mode: Select Static.IP if your ISP assigned you an IP address, subnet mask,
gateway, and DNS server addresses. In most cases, select Dynamic.
IP Address:
Enter the IP address (Static PPPoE only).
Username:
Enter your PPPoE username.
Password:
Enter your PPPoE password and then retype the password in the next
box.
Service Name: Enter the ISP Service Name (optional).
Reconnect Select either Always-on, On-Demand, or Manual.
Mode:
Maximum Idle
Enter a maximum idle time during which the Internet connection
Time: is maintained during inactivity. To disable this feature, enable Auto-
reconnect.
DNS Addresses:
Enter the Primary and Secondary DNS Server Addresses (Static PPPoE only).
MTU:
Maximum Transmission Unit - you may need to change the MTU for optimal performance with your specific ISP. 1492 is the default
MTU.
MAC Address:
The default MAC Address is set to the Internet port's physical interface MAC address on the Broadband Router. It is not recommended
that you change the default MAC address unless required by your ISP. You can use the Clone.Your.PC's.MAC.Address button to
replace the Internet port's MAC address with the MAC address of your Ethernet card.
D-Link DIR-860L User Manual

PPPoE (Username/Password)

28