D-Link DIR-803 User Manual

Wireless AC750
Dual Band Router
DIR-803
Package Contents
DIR-803 Wireless AC750 Dual Band Router
Power Adapter
Ethernet Cable
Quick Install Guide
Wi-Fi Configuration Card
If any of the above items are missing, please contact your reseller.
Hardware Overview
6
1 3 5 7 8 9 10
2 4
A solid green light indicates a proper connection to the
1 Power LED
power supply.
A solid green light indicates a proper connection to
2 Internet LED your broadband modem. The light will blink during data
transmission.
3 WPS LED The light will blink during the WPS process.
A solid green light indicates that the wireless segment is
4 Wireless LED
ready. The light will blink during data transmission.
A solid green light indicates a connection to an Ethernet
5 LAN LEDs (1-4)
device. The LED will blink during data transmission.
6 WPS Button Press to start the WPS process. The WPS LED will start to blink.
Connect Ethernet devices such as computers, switches,
7 LAN Ports (1-4)
and game consoles.
Connect your broadband modem to this port using an
8 Internet Port
Ethernet cable.
9 Power Port Connect the supplied power adapter.
Press and hold the reset button with a paper clip for six
10 Reset Button
seconds to reset the router to the factory default settings.
Minimum Requirements
Network Requirements:
• An Ethernet-based broadband modem
Web-based Configuration Requirements:
Computer with the following:
• Windows® or Mac OS® X operating system
• An installed Ethernet adapter or wireless adapter
Supported Browsers:
• Internet Explorer 7 or higher
• Safari 4 or higher
• Chrome
• Firefox
Before you Start
• Users with DSL providers - If you are using a PPPoE connection, you will need
your PPPoE user name and password. If you do not have this information, contact
your Internet provider. Do not proceed until you have this information.
• Users with Cable providers - Make sure you unplug the power to your modem.
In some cases, you may need to turn it off for up to 5 minutes.
• Advanced Users - If your ISP provided you with a modem/router combo, you will
need to set it to "bridge" mode so the DIR-803 router can work properly. Please
contact your ISP or refer to the user manual for your modem/router device.
Connect your Router
1
Unplug the power to your DSL or Cable modem.
Modem
Connect an Ethernet cable from the yellow Internet port of the router to the
2
Ethernet port on your DSL or Cable modem.
Ethernet Port
Internet Port
RESET
4 3 LAN 2 1 INTERNET 5V 1A
DIR-803
Modem
Connect another Ethernet cable from the Ethernet port on your computer
3
to one of the LAN ports on the router.
Computer
Ethernet Cable
4 3 LAN 2 1 INTERNET 5V 1A RESET
DIR-803
Plug the power back into your DSL or cable modem. Please wait about one
4
minute before continuing.
Computer
4 3 LAN 2 1 INTERNET 5V 1A RESET
DIR-803
Modem
5 Plug the power adapter into your router and connect to an available power
outlet or surge protector.
Computer
4 3 LAN 2 1 INTERNET 5V 1A RESET
DIR-803
Modem
After the router has powered up, verify that the Power and Internet LEDs are
6
both lit then continue with the Configuration section on the other side.