Dynamic Ip (Dhcp) - D-Link DIR-809 User Manual

Section 3 - Configuration
My Internet Connection is: Dynamic IP (DHCP)
This option allows the router to obtain an IP address automatically from the WAN device that is connected to the Internet
port.
Note: If you're not sure about the type of Internet Connection you have, please contact your Internet Service Provider (ISP)
for assistance.
After selecting Dynamic IP, the following parameters will be available for configuration:
Host Name: The Host Name is optional but may be required by some ISPs. Leave blank
if you are not sure.
MAC The default MAC Address is set to the Internet port's physical interface
Address: MAC address on the Broadband Router. It is not recommended that you
change the default MAC address unless required by your ISP. You can use
the Clone Your PC's MAC Address button to replace the Internet port's
MAC address with the MAC address of your Ethernet card.
Primary DNS:
Enter the Primary DNS IP address used here.
Secondary Enter the Secondary DNS IP address used here. This field is normally
DNS:
optional. Only one DNS address is required for a functional Internet
connection, but using a second DNS address provides more stability.
MTU: Maximum Transmission Unit - you may need to change the MTU for opti-
mal performance with your specific ISP. 1500 is the default MTU.
D-Link DIR-809 User Manual

Dynamic IP (DHCP)

18