Turning Lanesense On Or Off - Jeep 2016 Cherokee Owner's Manual

LaneSense system uses a forward looking camera to
detect lane markings and measure vehicle position
within the lane boundaries.
When both lane markings are detected and the driver
unintentionally drifts out of the lane (no turn signal
applied), the LaneSense system provides a haptic warn-
ing in the form of torque applied to the steering wheel to
prompt the driver to remain within the lane boundaries.
If the driver continues to unintentionally drift out of the
lane, the LaneSense system provides a visual warning
through the Electronic Vehicle Information Center (EVIC)
or Driver Information Display (DID) to prompt the driver
to remain within the lane boundaries.
The driver may manually override the haptic warning by
applying torque into the steering wheel at any time.
When only a single lane marking is detected and the
driver unintentionally drifts across the lane marking (no
turn signal applied), the LaneSense system provides a
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 219
visual warning through the EVIC/DID to prompt the
driver to remain within the lane. When only a single lane
marking is detected, a haptic (torque) warning will not be
provided.
NOTE: When operating conditions have been met, the
LaneSense system will monitor if the driver's hands are
on the steering wheel and provides an audible warning
to the driver when the driver's hands are not detected on
the steering wheel. The system will cancel if the driver
does not return their hands to the wheel.

Turning LaneSense ON Or OFF

The default status of LaneSense is "OFF".
The LaneSense button is located on the switch panel
below the Uconnect display.
I n f o r ma t i o n P r o v i d e d b y :
3