To Enter Remote Start Mode; To Exit Remote Start Mode Without Driving The Vehicle; To Exit Remote Start Mode And Drive The Vehicle - Jeep 2016 Cherokee Owner's Manual

Hide thumbs Also See for 2016 Cherokee:

Table of Contents

32 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

To Enter Remote Start Mode

Push and release the REMOTE START button

RKE transmitter twice within five seconds. The vehicle

doors will lock, the parking lights will flash, and the

horn will chirp twice (if programmed). Then, the

engine will start, and the vehicle will remain in the

Remote Start mode for a 15-minute cycle.

• If an engine fault is present or fuel level is low, the

vehicle will start and then shut down in 10 seconds.

• The park lamps will turn on and remain on during

Remote Start mode.

• For security, power window and power sunroof op-

eration (if equipped) are disabled when the vehicle is

in the Remote Start mode.

• The engine can be started two consecutive times with

the RKE transmitter. However, the ignition must be

cycled by pushing the START/STOP button twice (or

the ignition switch must be cycled to the ON/RUN

position) before you can repeat the start sequence for a

third cycle.

To Exit Remote Start Mode Without Driving The

Push and release the REMOTE START button one time or

allow the engine to run for the entire 15-minute cycle.

NOTE: To avoid unintentional shutdowns, the system

will disable the one time push of the REMOTE START

button for two seconds after receiving a valid Remote

Start request.

Before the end of 15-minute cycle, push and release the

UNLOCK button on the RKE transmitter to unlock the

I n f o r ma t i o n P r o v i d e d b y :

Table of Contents