Turning Lanesense On Or Off; Lanesense Warning Message - Jeep CHEROKEE User Manual

will also operate in this manner when only a
single lane marking is detected and the driver
unintentionally drifts across the lane marking
(no turn signal applied).
The driver may manually override the haptic
warning by applying torque into the steering
wheel at any time.
When only a single lane marking is detected
and the driver unintentionally drifts across
the lane marking (no turn signal applied), the
LaneSense system provides a haptic warning
in the form of torque applied to the steering
wheel, as well as a visual warning in the
instrument cluster display, to prompt the
driver to remain within the lane boundaries.
NOTE:
When operating conditions have been met,
the LaneSense system will monitor if the
driver's hands are on the steering wheel and
provide an audible and visual warning to the
driver when the driver's hands are not
detected on the steering wheel. The system
will cancel if the driver does not return their
hands to the wheel.

Turning LaneSense On Or Off

The default status of LaneSense is "off".
The LaneSense button is located on the
switch panel below the Uconnect display.
To turn the LaneSense system on,
push the LaneSense button (LED
turns off). A "LaneSense On"
message is shown in the instrument
cluster display.
To turn the LaneSense system off, push the
LaneSense button once (LED turns on).
NOTE:
The LaneSense system will retain the last
system state, on or off, from the last ignition
cycle when the ignition is changed to the ON/
RUN position.

LaneSense Warning Message

The LaneSense system will indicate the
current lane drift condition through the
instrument cluster display.
Base Instrument Cluster Display — If Equipped
When the LaneSense system is on, the lane
lines are gray when both of the lane bound-
aries have not been detected and the Lane-
Sense telltale is solid white.
Left Lane Departure — Only Left Lane Detected
When the LaneSense system senses a lane

drift situation, the left thick lane line and
left thin lane line turn solid white. The
LaneSense telltale changes from solid
green to solid yellow. At this time, torque
is applied to the steering wheel in the
opposite direction of the lane boundary.
For example: If approaching the left side
of the lane, the steering wheel will turn
right.
When the LaneSense system senses the

lane has been approached and is in a lane
departure situation, the
system will show a solid white left line, a
solid gray right line, and a solid yellow tell-
tale.
NOTE:
The LaneSense system operates with the
similar behavior for a right lane departure
when only the right lane marking has been
detected.
LaneSense
169