Positioning The Weather Station - La Crosse WS9251 Instruction Manual

4. Neighbors using electrical devices operating on the 868 MHz signal frequency can also cause
interference.
Note:
When the 868 MHz signal is received correctly, do not re-open the battery cover of either the transmitter
or weather station, as the batteries may spring free from the contacts and force a false reset. Should this
happen accidentally then reset all units (see Setting up above) otherwise transmission problems may
occur.
The transmission range is about 100 m from the transmitter to the weather station (in open space).
However, this depends on the surrounding environment and interference levels. If no reception is
possible despite the observation of these factors, all system units have to be reset (see Setting up).

POSITIONING THE WEATHER STATION:

The weather station comes with a detachable stand that gives the option of table
standing or wall mounting. Before wall mounting, please check that the outdoor data can
be received from the desired locations.
To wall mount:
1. Fix a screw (not supplied) into the desired wall, leaving the head extended out
by about 5mm.
2. Remove the stand by pulling it away from the weather station. Using the back
hanging hole, carefully hang the weather station onto the screw.
Note: Always ensures that the unit locks onto the screw head before releasing.
POSITIONING THE TEMPERATURE TRANSMITTER:
The temperature transmitter can be placed on any flat surface or wall mount using the
bracket which doubles as a stand or wall mount base.
To wall mount:
1. Secure the bracket onto a desired wall using the screws and plastic anchors.
2. Clip the transmitter onto the bracket.
Note: Before permanently fixing the transmitter wall base, place all units in the desired
locations to check that the outdoor temperature reading is receivable. In event that the
34