Before You Change The Preset Programmes - Danfoss TP4 User & Installation Instructions Manual

Electronic programmable room thermostat
Table of Contents

Advertisement

Available languages

Available languages

  • ENGLISH, page 1

Before you change the preset programmes

Please Note
The unit must be programmed in sequence and EVENT times
cannot be programmed out of sequence.
The event  time setting can be set at any time of day (normally
in the morning). The time settings for events  to 6 can only be
placed between the previous setting and .59.
If you want to leave a preset time as it is, simply press PROG to
move on to the next setting.
During programming, if no buttons are pressed for 2 to 3
minutes the unit will automatically return to RUN mode, and the
programme set up to that minute will be active.
!
If at any time you get confused and need to reset the unit to the
preset programmes, press and hold the + , – , s & t buttons at
the same time.
GB
5

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TP4 and is the answer not in the manual?

This manual is also suitable for:

Tp5

Table of Contents

Save PDF