Setting The Clock; Running Your Programme; Before You Change The Preset Programmes - Danfoss TP4000 Range User Manual

Electronic programmable room thermostat

Hide thumbs Also See for TP4000 Range:

1.4 Setting the Clock

Note: clock is displayed in 24 hour mode.

Press PROG and Λ until the time on the display

ﬂ ashes.

Use + or - to adjust the TIME (press and hold to

change in 10 min increments).

Press PROG to enter the TIME.

If you are happy to use the preset programmes

on page 6, you don't need to do anything else.

Your unit is now in RUN mode.

2.0 Advanced

Please Note

The unit must be programmed in sequence. Event times cannot

be programmed out of sequence.

If you want to leave a preset time as it is, simply press PROG to

move on to the next setting.

During programming, if no buttons are pressed for 2 minutes the unit

will automatically return to RUN mode, and the programme set up to

that minute will be active.

Danfoss Heating

Table of Contents

Show Quick Links