Running Your Programme; Before You Change The Preset Programmes - Danfoss TP5000 + RF Installation Instructions Manual

Running your programme

GB
If you are happy to use the preset programmes on page 8, you
don't need to do anything else.
To accept the presets close the front cover
and after 2 minutes the pre settings will
automatically be accepted (& colon will blink).
Your unit is now in RUN mode.

Before you change the preset programmes

Please Note
The unit must be programmed in sequence and ON/OFF
times cannot be programmed out of sequence.
If you want to leave a preset time as it is, simply press PROG
to move on to the next setting.
During programming, if no buttons are pressed for 2 to 3
minutes the unit will automatically return to RUN mode, and the
programme set up to that minute will be active.
!
If at any time you get confused and need to reset the unit to
the preset programmes press the + & – AND
simultaneously.
10
i2 24
20
& buttons