Accepting The Preset Programmes; Before You Change The Preset Programmes - Danfoss FP975 User Manual

Press PROG to display the time.
The words SET TIME will appear at
the top of the display and the time
will fl ash on and off .
Use the + or - buttons to set the
correct time (press and hold to
change in 10 min. increments).
GB
Setting the Day
The day of the week is set
automatically.

1.6 Accepting the Preset Programmes

If you are happy to use the preset
programmes on page 6, you don't
need to do anything else.
To accept the factory presets just
press the PROG button until the
time appears and the colon in the
display begins to fl ash.
Your unit is now in RUN mode
and will control your heating and
hot water according to the preset
programmes.

1.7 Before you Change the Preset Programmes

Your installer will have set your unit to operate in one of the following
modes:
• 5/2 day - one set of programmes for weekdays and another for
weekends (page 9-10).
• 7 day - diff erent settings for each day of the week
(page 11-128).
8
FP975