Before You Change The Preset Programmes - Danfoss TS715Si User Manual

1.7 Before you change the preset programmes

Your installer will have set your unit to operate in one of the following
modes:
• 5/2 day - one set of programmes for weekdays and another for
weekends (page 10-11)
• 7 day - diff erent settings for each day of the week.
(page 11-12)
• 24 hour - one set of programmes for the whole week.
(page 13)
See INSTALLER SETTING tick box on inside fl ap label to ascertain
which mode your unit is set.
Please Note
The unit must be programmed in sequence. ON/OFF times cannot
be set out of sequence.
If you want to leave a preset time as it is, simply press NEXT to
move on to the next setting.
Your installer will have set your unit to programme either 2 or 3
ON/OFFs per day. If your clock has been installed to allow 3 ON/
OFFs and you do not wish to use one of the ON/OFF settings,
simply programme the ON time to be the same as the OFF time
and the setting will not operate.
Danfoss Heating
INSTALLER SETTING
24 Hour
5+2 Day
7 Day
GB
9