Special Tools
Order special tools from the TORO SPECIAL TOOLS
AND APPLICATIONS GUIDE (COMMERCIAL PROD-
UCTS) .
Gauge Bar Assembly – P/N 13–8199
Used to verify height–of–cut.
Backlapping Brush Assembly – TOR299100
Used to apply lapping compound to cutting units while
keeping the operator's hands at a safe distance from the
rotating reel.
Bedknife Screw Tool – TOR510880
This screwdriver–type bit is made to fit Toro bedknife at-
taching screws. Use this bit with a torque wrench to se-
cure the bedknife to the bedbar.
DO NOT use and air or manual impact wrench with this
tool.
Greensmaster 1000/1600
Some tools may have been supplied with your mower or
available as TORO parts. Some tools may also be avail-
able from a local supplier.
Page 7 – 5
Figure 3
Figure 4
Figure 5
Cutting Unit