Kickstand - Toro Greenmaster 1000 Service Manual

Kickstand

1. Cap screw
2. Cap screw
3. Lock washer
4. Spring bracket
Removal
1. Park mower on a level surface. Make sure the en-
gine is OFF.
2. Pivot kickstand up against the handle and hold
there.
3. Use a pliers to remove the extension spring from the
spring retainer (Fig. 15).
4. Remove both lock nuts (10), flat washers (9), cap
screws (1), and spacers (11) from the kickstand (8) and
frame. Remove kickstand from the frame (Fig. 14).
Installation
1. Make sure mower is parked on a level surface and
the engine is OFF.
2. Position kickstand (8) inside the mower frame. In-
sert capscrews (1) through the frame, spacers (11), and
kickstand (Fig. 14).
3. Secure cap screws (1) with flat washers (9) and lock
nuts (10). Tighten fasteners (Fig. 14).
4. Pivot kickstand up against the handle and hold
there. Use a pliers to reinstall the extension spring to the
spring retainer (Fig. 15).
Greensmaster 1000/1600
6
7
1 2 3 4
5
11
9
FRAME
Figure 14
5. Extension spring
6. Cap screw
7. Spring retainer
8. Kickstand
Page 6 – 13
9
12
8
10
9. Flat washer
10. Lock nut
11. Spacer
12. Flange lock nut
1
3
4
1. Kickstand
2. Extension spring
NOTE THE POSITION
OF THE STOP
2
Figure 15
3. Spring retainer
4. Cap screw
Wheels and Accessories