Toro Greenmaster 1000 Service Manual page 6

10. Check the safety interlock switch daily for proper op-
eration; see Component Testing in Chapter 5 – Electri-
cal System. Replace malfunctioning switches before
While Operating
11. Do not run the engine in a confined area without ad-
equate ventilation. Exhaust fumes are hazardous and
could be deadly.
12. Always stand behind the handles when starting and
operating the machine.
13. To start and stop the engine:
A. Open fuel shut-off valve.
B. Verify that the traction drive lever on handle is in
NEUTRAL position and reel drive lever on mower is
DISENGAGED.
C. Move on/off switch to ON position, set choke to
full choke position (cold start) and throttle to half
throttle.
D. Pull starter cord to start engine.
E. Move throttle to SLOW and on/off switch to OFF
position to stop engine.
14. To transport mower from one area to another:
A. Install transport wheels.
B. Disengage reel drive lever.
C. Start engine.
D. Press down on handle to raise front of mower
and engage traction drive.
Maintenance and Service
20. Before servicing or making adjustments to the ma-
chine, stop the engine and pull the spark plug wire off
spark plug to prevent accidental starting of the engine.
21. To make sure entire machine is in good condition,
keep all nuts, bolts, screws and belts properly tightened.
22. If major repairs are ever needed or assistance is re-
quired, contact an Authorized TORO Distributor.
23. To reduce potential fire hazard, keep the engine
area free of excessive grease, grass, leaves and accu-
mulation of dirt.
24. If the engine must be running to perform a mainte-
nance adjustment, keep hands, feet, clothing, and any
parts of the body away from the cutting unit and any
moving parts. Keep everyone away.
Safety
operating machine. (After every two years, replace the
interlock switch in the safety system, whether it is work-
ing properly or not.)
15. Before beginning mowing operation:
A. Stop engine.
B. Disengage traction drive.
C. Remove transport wheels.
D. Engage reel drive lever.
16. Before emptying basket of clippings, disengage
traction drive, reduce engine speed and move on/off
switch to off position.
17. Do not touch engine, muffler or exhaust pipe while
engine is running or soon after it has stopped because
these areas are hot enough to cause burns.
18. If the cutting unit strikes a solid object or vibrates ab-
normally, stop immediately, turn engine off,wait for all
motion to stop and inspect for damage. A damaged reel
or bedknife must be repaired or replaced before opera-
tion is commenced.
19. Whenever machine is left unattended, be sure en-
gine is stopped and cutting unit reel is not spinning.
Close fuel shut-off valve if machine is not to be used for
an extended period of time.
25. Do not overspeed the engine by changing governor
settings. Maximum engine speed is 3600 rpm. To as-
sure safety and accuracy, have an Authorized Toro Dis-
tributor check maximum engine speed with a
tachometer.
26. Engine must be shut off before checking oil or ad-
ding oil to the crankcase.
27. To be sure of optimum performance and safety, al-
ways purchase genuine TORO replacement parts and
accessories. Replacement parts and accessories made
by other manufacturers could be dangerous. Such use
could void the product warranty of The Toro Company.
Page 1 – 2
Greensmaster 1000/1600