Lubrication - Toro Greenmaster 1000 Service Manual

Lubrication

The mower should be greased at least after every 25
hours of operation. Lubricate grease fittings using No. 2
multipurpose lithium base grease. A hand operated
grease gun is recommended for best results.
1. Park mower on a level surface. Make sure engine
is OFF. Remove high tension lead from the spark plug.
2. Wipe each grease fitting with a clean rag.
IMPORTANT: Do not apply too much pressure or
grease seals will become permanently damaged.
3. The grease fitting locations are as follows:
A. Both bearing housings for the differential axles,
both flangettes for the drum shafts, and the flangette
on the countershaft housing (Fig. 68).
B. The clutch housing and bearing housing for the
power shaft (Fig. 69).
4. Wipe off excess grease.
Greensmaster 1000/1600 Page 4 – 35
Figure 68
Figure 69
Traction and Reel Drive Systems