Toro Greenmaster 1000 Service Manual page 62

Note: The locking collar securing the long axle to the
countershaft housing is a eccentric flange type.
11. Loosen the set screw on the locking collar. Unlock
collar by striking it with a punch in the clockwise direction
(Fig. 58).
12. Remove three cap screws and lock washer secur-
ing the box cover to the countershaft housing. Pull cover
from housing. Loosen both carriage bolts and lock nuts
securing the idler pulley to the countershaft housing.
Slide idler pulley away from the belt (Fig. 59).
13. Use a rubber hammer to carefully tap the counter-
shaft housing off the power shaft. Alternate the hammer
between the long axle and the bearing housing end of
the counter shaft housing to prevent damage to the
bearings(Fig. 60).
14. Remove three socket head cap screws and lock
washers from the side plate (RH) and bearing housing
(Fig. 61).
15. Slide differential assembly to the left to allow remov-
al of the belt without bending or twisting. Remove old
belt from the differential pulley and countershaft pulley
(Fig. 62).
2
CLOCKWISE
Figure 58
1. Axle (Long)
3
4
2
Figure 59
1. Lock nut (Idler pulley)
2. Countershaft housing
Traction and Reel Drive Systems
1
2. Locking collar
1
3. Differential boot
4. Box cover
Page 4 – 32
2
Figure 60
1. Countershaft housing
2. Power shaft
3
Figure 61
1. Socket head cap screw
2. Side plate (LH shown)
3
Figure 62
1. Differential assembly
3
1
4
3. Axle (Long)
4. Bearing housing
3
3
3. Bearing housing
3
LEFT
2. Belt
Greensmaster 1000/1600