Toro Greenmaster 1000 Service Manual page 131

2
ASSEMBLY
RIGHT
FRONT
1. Belt cover
2. Clutch drive adapter
3. Needle bearing
4. Clutch pin
5. Compression spring
6. Driver pulley
Removal
Note: An older model of the GR 1000 has be used for
illustrating purposes The procedures are the same for
both older and newer models except as noted.
1. Make sure engine is OFF. Remove high tension
lead from the spark plug. Place mower on a level surface
or on a workbench.
2. Remove four cap crews and lock washers and then
the reel drive cover (Fig. 19).
3. On newer models, loosen drive belt on the reel drive
assembly as follows:
A. Lower grass shield by loosening both cap
screws and lock nuts securing the shield to the
frame (Fig. 20).
B. Loosen cap screw on clutch housing. Pivot idler
pulley counterclockwise (arrow direction) to loosen
reel drive belt. Remove reel drive belt (Fig. 21).
1
Figure 19
1. Cap screw & lock washer
Greensmaster 1000
4 5
6
3
7
CLUTCH
7. Roller bearing
8. Belleville washer
9. Clutch release disc
10. Special screw
11. Flange bushing
2
2. Reel drive cover
8
9
10
11
Figure 18
NEWER MODELS
1. Grass shield
2. Cap screw
NEWER MODELS
1. Cap screw
2. Clutch housing
Page 8 – 15
1
16
13
12
14
12. Set screw
13. Clutch knob
14. Flat washer
15. Lock nut
16. Poly washer
2
4
Figure 20
3. Lock nut
4. Frame
4
3
1
Figure 21
3. Idler pulley
4. Drive belt
Grooming Reel Kit
15
1
3
2