Toro Greenmaster 1000 Service Manual page 89

B. If the operator presence kit is not installed, se-
cure console bracket to the brake skid bracket with
three screws.
3. Position console (29) over the console brackets (10
and 19). Secure console to both brackets with four
screws (13) (Fig. 2).
4. Run new brake cable to the countershaft assembly.
Install new brake cable to the countershaft housing and
brake lever as follows (Fig. 5):
Greensmaster 1000/1600
A. Attach brake cable to the counter shaft housing
and tighten the rear nut.
B. Secure cable eyelet to the brake lever with
shoulder bolt and lock nut.
5. Install new cable ties to the left side of the handle.
6. Adjust brake cable and close bellcrank cover (see
Service/Park Brake Adjustment in Chapter 7 – Traction
and Reel Drive Systems).
Page 6 – 7
Wheels and Accessories