Table of Contents
Advertisement
6. Important information
6.4
Regulatory compliance information
Indications for use
This device is intended to be used in operation rooms, to display images from endoscopic cameras, room
and boom cameras, ultrasound, cardiology, PACS, anesthesiology and patient information. It is not in-
tended for diagnosis.
FCC Class A
This equipment has been tested and found to comply with the limits of a class A digital device, pursuant
to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruc-
tion manual, may cause harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the user will be required to correct
the interference at his own expense.
Canadian notice
This ISM device complies with Canadian ICES-001.
Cet appareil ISM est conforme à la norme NMB-001 du Canada.
6.5
Cleaning and disinfection
Instructions
•
Be sure to unplug the power cord from the mains when cleaning your LCD monitor.
•
Take care not to scratch the front surface with any hard or abrasive material.
•
Dust, finger marks, grease etc. can be removed with a soft damp cloth (a small amount of mild deter-
gent can be used on the damp cloth).
•
Wipe off water drop immediately.
Possible cleaning solutions
•
70 percent isopropyl alcohol
•
1.6 percent aqueous ammonia
•
Cidex® (2.4 percent glutaraldehyde solution)
•
Sodium hypochlorite (bleach) 10 percent
•
"Green soap" (USP)
•
0.5 percent Chiorhexidine in 70 percent isopropyl alcohol.
•
Like Cleansafe® optical cleaning liquid
6.6
Explanation of symbols
Symbols on the device
On the device or power supply, you may find the following symbols (nonrestrictive list):
32
(451920611502) K5902088 MDSC-8258 08/09/2014
Advertisement
Table of Contents
