Connecting The Power Cords; Connecting Ac Power Cords - NEC S1500 Setup Manual

3.3

Connecting the Power Cords

The disk array unit, the FC disk enclosure, and the SATA disk enclosure all have a redundant power
configuration to prevent the entire unit from shutting down due to a single failure. Therefore, connect
a power cord to each power supply of the disk array unit, FC disk enclosure, and / or SATA disk
enclosure when operating the disk array unit.
3.3.1

Connecting AC Power Cords

3-3-1-1 Disk Array Unit
Use the AC power cord provided with the disk array unit.
Make sure that the power switch is set to OFF, and take the following steps to connect the power cord.
1. Insert the plug of the AC power cord provided with the disk array unit to an AC outlet.
2. Secure the AC power cords with the AC cable clamp.
OFF
Figure 3.3.1 Rear View of the Disk Array Unit
-
Power plugs
-
13
ON