Notes On Use - NEC S1500 Setup Manual

The following table includes information necessary for the proper and safe operation of the disk array
unit.
Do not use the disk array unit in an area of high humidity. If so, a fault, electrical
shock, or fire may occur.
Do not use the disk array unit in an area where inflammable gas and/or
combustible materials are placed. If so, a fire or explosion may occur.
Do not overload AC outlets with power cords. If so, a fire may occur.
Do not put heavy objects on a power cord. If so, the insulating coating of the
power cord may be damaged, fire may occur, and/or you may be electrically
shocked.
Do not install the disk array unit in a dirty or dusty environment. Remove any dust
adhering to AC outlets and the plugs of power cords. If dust remains adhering to
an AC outlet and/or plug, a fire may occur.
Do not connect the plug of a power cord to an AC outlet with a wet hand. If so, you
may be electrically shocked.
While the disk array unit can accept power in the range of 100 - 240 VAC (50/60
Hz), the power cord shipped with the disk array unit can only accept 220 – 240
VAC. Use 220 – 240 VAC (50/60 Hz) when the included power cord is used. Using
power of a different voltage may cause electric shock, smoke, and/or fire to occur.
The controller of the disk array unit contains a lithium battery. Do not remove the
lithium battery. The lithium battery may explode when it is brought close to fire or
immersed in water. Dispose of the controller according to local ordinance. Contact
your local government for details.
If the disk array unit does not operate normally due to the life of the lithium
batteries, contact your service representative. Do not disassemble the controller,
or replace or charge battery by yourself.

Notes on Use

WARNING
- -
iii