NEC S1500 Setup Manual page 57

(7) Network configuration
Set the network information for the disk array unit.
Specify a valid value
other than 10.1.0.0 or
10.1.0.255
Set it to 0.0.0.0. if
you have no
gateway address
to specify.
Watch Server Setting
Select the "Watch Server" when you wish to allow access only to specific WebSAM NEC
Storage Manager servers (commands coming from an IP address different than the ones
specified are not accepted).
The Watch Server setting dialog box specifying IP addresses appears.
Up to eight IP addresses can be specified.
[Watch server configuration dialog]
Select this if you wish to
grant access to specific
WebSAM NEC Storage
Manager servers.
If a single controller
connection is selected,
you can only modify
the Controller 0
network configuration.
Select this if you do not wish to restrict access.
Commands issued by any WebSAM NEC
Storage Manager servers (regardless of their
IP Addresses) will be accepted.
- -
40
Specify a valid value
other than 10.1.0.0 or
10.1.0.255
Set it to 0.0.0.0. if
you have no
gateway address
to specify.