Periodic Checks And Adjustments - MULTIQUIP MTX SERIES Service Manual

9. PERIODIC CHECKS AND ADJUSTMENTS

9.1 Table of scheduled checks
How often?
Daily
(before starting operation)
After first 20 hours
Every 50 hours
Every 200 hours
Every 200 to 300 hours
Every 2 years
9.2 Periodic checks and adjustments
(1) Daily maintenance
Carefully wipe off any mud, dirt or oil from each
component.
If oil leaks, retighten the joints and check
again.
(2) Maintenance after every 50 hours of operation
Remove the fuel filter cup and clean the inside
thoroughly. (fig.34)
Remove the spark plug and clean it. Then
adjust the gap to 0.6 to 0.7 mm.
(3) Replacing the lubrication oil
Remove the drain plug on the lower part of the
machine body and drain the oil inside. Then
add the specified amount of new oil.(fig.35)
Place to check Item to check
Appearance Flaws, deformity, dirt
Air cleaner Dirt, flaws, deformation
Bolts, nuts Loose or missing parts
Handle Flaws, deformity, cracks, damage
Rubber damper Wear, deformity, cracks, damage
Engine oil Dirt, oil level
Lubrication oil in Dirt, oil level
the main body
Fuel tank Leaks, fuel level, dirt
Fuel system Leaks, wear, looseness
Engine oil Replace once, after the first 20 hours
Spark plug Clean, adjust gap
Engine oil Replace
Lubrication oil in Replace
the main body
Pre-air cleaner Cleaning
(primary element)
Fuel hose Replace
16
Oil gauge
Drain plug
Table 3
Oil etc.
Engine oil
Engine oil
Gasoline
Engine oil
Engine oil
Engine oil
Lamp kerosene
Fuel filter
fig.34
fig.35