Handle; Combination Lever - MULTIQUIP MTX SERIES Service Manual

8.4 Disassembly and reassembly the

handle.

3
4
7
6
43
5
41
43
42
41
42
(1) Disassembly
A. Remove the fuel tank (10) from the handle by
unscrewing 3 pcs bolts (11) after disconnect-
ing the fuel hose (19).
B. Unscrew 2 pcs tapping screws (22) which
fixing the meter finisher from the underside of
the fuel tank, and remove the hour & tachom-
eter and the meter finisher at the same time
because they are tightening at the same time.
C. In case of replacing the fuel filter (14) which
installed in the fuel tank, remove the fuel filter
holder (16) by unscrewing 3 pcs nuts (17)
which is fixing it.
(2) Reassembly
Reassemble with the reversed procedure of
disassembly with attention to the following
terms.
A Replace the damaged fuel hoses (19, 103,
104) with new one.
B.
Be careful not too tightening the tapping
screws (22) which is fixing the hour &
tachometer and the meter finisher because
the threaded holes of the meter finisher made
by plastic is broken by over tightening torque.
9
10
54
51
53
57
56
22
14
15
16
18
20
19
17
A
20
11
101
A
101
fig.26
8.5 Disassembly and reassembly the

combination lever

16
6
5
55
52
5-1 Disassembly and reassembly
the throttle wire
103
(1) Disassembly
101
A. In case of removing the throttle wire (5),
102
move to idling position of the lever (2) ready.
101
(fig.28)
104
B. Remove the end cap (11) and unscrew a bolt
(10) and 2 pcs nuts (8).
C. Remove the slider (9) and the inner wire from
there.
D. Remove the outer wire by unscrewing 2 pcs
nuts (7) after removing the wire cap (6).
(2) Reassembly
Reassemble with the reversed procedure of
disassembly.
5-2 Disassembly and reassembly
the fuel cock
(1) Disassembly
A.
In case of removing the fuel cock (3), move to
high speed position of the lever (2) ready.
(fig.29)
14
8
3
17
7
1
20
4
fig.27
11
8
10
9
2
15
14
19
13
12
18
fig.28