Crankcase - MULTIQUIP MTX SERIES Service Manual

J. Remove the piston end (4) by shocking the
t o p e n d o f c e n t e r b o l t w i t h t h e p l a s t i c
hammer. (fig.16)
If it doesn't remove, shock it after tightening
the center bolt again.
K. Remove the protection sleeve (51) from the
spring cylinder (12). (fig.17)
Disassembling the guide cylinder and
spring cylinder are completed above.
(2) Reassembly
Reassemble with the reversed procedure of
disassembly with attention to the following
terms.
A. Replace the disassembled O-ring with new
one.
B. Replace the main spring (9) as a set with
upper and lower when replacing it
C. Replace the bellows (23) with new one, if it is
damaged.
D. The bellows (23) is easy to install by applying
grease to inner wall of its opening.
E. Be careful not to pinch and to twist the O-ring
when assembling the spring cylinder (12) and
guide cylinder (20).
F. Apply molybdenum grease to inner sliding
parts of spring cylinder (12), guide cylinder
(20) and main spring (9) before assembling
them.
G. Assemble the foot plate (13) to the spring cyl-
inder (12) with the spring cylinder remover
(P/N:9830-10040) after fitting position of the
oil drain plug (17) of foot plate and the oil fill
Center bolt
fig.16
Protection sleeve
Spring cylinder
fig.17
12
8.3 Disassembly and reassembly the

crankcase.

33
32
47
31
44
101
11
10
12
19
106
15
13
20
21
(1) Disassembly
A. Remove the engine assembly as per 8-1.
B. Separate the crankcase and the guide cylin-
der as per 8-2.
C. Remove the handle assembly by unscrewing
4 pcs bolts (4) which fixing it.
D. Remove the air cleaner assembly (33) by un-
screwing 2 pcs bolts (40) and 2 pcs bolts
(39), which is fixing it. (fig.19)
No.
Size
39 Bolt M8X55
40
Bolt M8X15
42
39
40
23
2
47
17
16
9
14
3 5
1
6
7
fig.18
Tightening
Remarks
torque
24.5N ・ m
(18.1ft ・ lbf)
24.5N ・ m
(18.1ft ・ lbf)
fig.19
22
21
4