Using The Radio For The Fi Rst Time - Roberts Blutune 40 Manual

Using the radio for the fi rst time
1. Place your radio on a fl at surface.
2. Fully extend the wire aerial located on the rear of your radio. Place
the wire antenna so that it is as straight as possible extending either
above or below the radio.
3. Insert the adaptor plug into the DC socket located on the rear of your
radio. Plug the adaptor into a standard 13 amp mains socket outlet.
The display will show 'WELCOME' for a few seconds. During this time
the radio is scanning to fi nd a DAB radio signal. After a short time the
current time and day will appear on the display.
4. If no signal is found, '0:00' will be displayed. It may be necessary to
relocate your radio to a position giving better reception. You should
then carry out a scan to fi nd stations as described on page 9.
IMPORTANT: The mains adaptor is used as the means of connecting
the radio to the mains supply. The mains socket used for the radio must
remain accessible during normal use. In order to disconnect the radio
from the mains completely, the mains adaptor should be removed from
the mains socket outlet completely.
Characters appearing on the LCD display indicate that the radio is connected
to and powered from the mains supply.
If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri)
4