Automatically Updating The Clock - Roberts Blutune 40 Manual

Automatically updating the clock

Your radio will usually set the clock time using the DAB signal. You may
specify that the radio sets its clock from the DAB or FM waveband, either
waveband or none. If you choose none you will need to set the clock manually.
1. Press and release the On/Off button to switch on the radio.
2. Press and release the Menu button until the advanced menu shows
on the display.
3. Rotate the Tuning control until 'SYSTEM' appears on the display.
Press and release the Tuning control.
4. Rotate the Tuning control until 'TIME' appears on the display. Press
and release the Tuning control.
5. Rotate the Tuning control until 'UPDATE' appears on the display.
Press and release the Tuning control.
6. Rotate the Tuning control to choose an update option from, 'ANY,
DAB, FM or NONE.
7. Press and release the Tuning control to confi rm your choice.
8. The radio will set its time according to the information received. The
radio will return to the previous menu display.
If a signal is not found you should then either position the radio or its
aerial so that a signal can be received, or revert to manual clock mode
(see page 30).
If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri)
1
2
3-7
32