Installation And Configuration - Intermec PENKEY 6100 Programmer's Reference Manual

Supporting DOS Applications

Installation and Configuration

IRDAPDRV.EXE
PRDRV.SYS
Required CONFIG.SYS Entry
device=d:\pathname\prdrv.sys
install=d:\pathname\irdapdrv.exe –t6100
Required AUTOEXEC.BAT Entry
Usage
PRDRV.SYS
IRDAPDRV
" NOTE:
Use only the switches shown here. This driver is a multi-platform program, providing fea-
tures for all of the 6000 Series platforms. None of the other switches are intended for the
6100 Computer and could cause a malfunction, if used on this platform.
R
2-14 PEN*KEY 6100 Computer Programmer's Reference Guide
d:\pathname
t6100
[fileNameToUse]
fileNameToUse
[ –? –bn –dn –fs –n –rn –t6100 –x ]
must
SECTION 2
must