Intermec PENKEY 6100 Programmer's Reference Manual page 269

APPENDIX A
; scanner.
; external comm 1 connections.
; values are TRUE and FALSE.
EnableScannerWhenDriverLoads=FALSE
; DisplayScanningDataDialog controls whether or not the Scanning Data.
; Dialog is displayed when the trigger is pulled.
; and FALSE.
DisplayScanningDataDialog=TRUE
; ShowWindowOnLoad controls whether or not the scanner window icon is
; displayed on the screen.
; scanner window.
ShowWindowOnLoad=TRUE
; EnableScanCodes controls whether or not the scanner includes Scan Codes in
; the key messages that it generates.
EnableScanCodes=TRUE
; ExternalFlashOnScan controls whether the Good Scan light are flashed
; manually by the scanner driver when the data is received.
; values are: TRUE and FALSE.
ExternalFlashOnScan=FALSE
; AimingBeamDuration controls the length of time in milliseconds the long
; range scanner using a dedicated UART emits an aiming beam.
; scanners should have this option set to 0 (the default value).
AimingBeamDuration=0
; Use this option to set the Base Address on which the driver looks for the
; Scanner UART.
; 1016 (3f8) for COM1, 760 (2f8) for COM2.
DedicatedUARTAddress=488
; Use this option to set the IRQ Line on which the Scanner UART interrupts.
; Default setting is 5.
DedicatedUARTIRQ=5
; This option is applicable to Hand held Scanners only. It sets the value of
; the Terminating character of the packet sent by the Scanner.
; setting is 03 (ETX).
Postamble=03
;– – – – – – – – – – – – – – – – – – – – – – – – – – – – – – –
[NPCP Driver]
; Name of device Windows outputs to and is directed out the IR Port.
; option must match the settings in WIN.INI
DeviceName=LPT1
; Comm Port Address and IRQ
CommAddress=0x03F8
CommVector=0x0C
; Determines FIFO usage on UART.
FIFODepth=16
; Determines if power on the port turns on and off.
; non-Norand APM services.
PowerManage=FALSE
; This option disables/enables the QueryAbort processing during printing.
; The default setting is FALSE.
; Print job once it is started.
ProcessQueryAbort=FALSE
; This option is valid only if the FIFODepth setting is > 0.
; Receive interrupt trigger level.
; 0–3.
; setting, a value of 0 causes Chip to interrupt on every character.
; However, on an ST650 UART this implies interrupt on every 8 characters (or
; after 4 char times if there is at least one character in FIFO).
; further details, refer to the UART documentation on setting the top 2 bits
; in the FIFO Control Register.
FIFOTriggerLevel=0
If TRUE it does NOT allow multiplexing of the scanner and
If this is FALSE there is no way to get to the
The valid values are:
The default setting is:
Other valid settings are:
Other valid settings are: 10 (LF), 13 (CR).
The Receive interrupt trigger is Chip dependent.
PEN*KEY
This option uses more power.
Valid values are:
TRUE and FALSE.
Valid values are: TRUE and FALSE
488 (1e8). Valid settings are:
4 for COM1, 3 for COM2.
A value of 0 disables.
May not work with all
This disables the ability to cancel the
Valid settings are: TRUE and FALSE.
Default value is 0.
R
6100 Computer Programmer's Reference Guide
Sample Configuration Files
The valid
TRUE
The valid
All other
The default
This
Sets the
Valid settings are
On 550 UART
For
A-7