Intermec PENKEY 6100 Programmer's Reference Manual page 270

Sample Configuration Files
; Use this option to Install/Deinstall the ISR for every Print Job.
; useful if the IRQ is multiplexed with some other device such as the
; Scanner.
; settings are 0 and 1.
IRQMultiplex=0
;– – – – – – – – – – – – – – – – – – – – – – – – – – – – – – –
[IrDA Driver]
; DeviceName specifies the name of the device that Windows is sending its
; output to.
; that Windows attempts to send to the DOS device LPT1, is sent to the IrDA
; port.
DeviceName=LPT2
; Use this option to set the Base Address on which the Driver looks for the
; IR UART.
; COM1, 760 (2f8) for COM2, 1000 (3e8) for COM3.
UARTAddress=1000
; Use this to set the IRQ Line on which the UART interrupts.
; setting is 3 (COM2).
UARTIRQ=3
; This sets the type of the Hand Held computer.
; Valid settings are PENKEY, 6100, 6600, JETEYE, and OMNIBOOK.
Technology=PENKEY
;– – – – – – – – – – – – – – – – – – – – – – – – – – – – – – –
[Norand 6805 Printer]
; This forces the drivers to use Graphics commands for entire Document.
; Valid settings are TRUE/FALSE. Default value is: FALSE.
DoGraphicsOnly=FALSE
; This sets the idle time in seconds after which the Printer is Awakened
; while printing multiple pages.
; 10–50.
Timeout=10
; This controls the # of NULL characters sent to the printer, after the
; Initialize command, for it to Wakeup properly.
; Valid settings are 200–500.
; printing.
WakeupChars=200
;– – – – – – – – – – – – – – – – – – – – – – – – – – – – – – –
[speaker.drv]
;– This line should be 40–45 on a Pen*Key 25
CPU Speed=40
Volume=900
Version=774
Max seconds=3
Enhanced=0
;– Leave at 0 for best sound.
; sound playback causes problems with your configuration.
; interrupts during sound playback also causes the DOS clock to lose time
; when sounds are played.
; every 10 seconds or so.
;– – – – – – – – – – – – – – – – – – – – – – – – – – – – – – –
[keyboard]
subtype=
type=4
keyboard.dll=
oemansi.bin=
;– – – – – – – – – – – – – – – – – – – – – – – – – – – – – – –
;–––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
; Some Norand drivers and utilities write a version string to the
; "boot.description" section below to aid in driver identification.
R
A-8 PEN*KEY 6100 Computer Programmer's Reference Guide
The default setting is 0 (ie. no multiplexing).
The default value is LPT1.DOS which Causes all print output,
Default setting is 760 (2f8).
Other valid setting is 4 (COM1). 6100 setting is 14.
Default setting is 10.
Setting a Lower value may disrupt Graphics
Set to 1 if having interrupts disabled during
NORAPM.DLL fixes this by correcting the DOS clock
Leave interrupts enabled=0
The valid
Valid settings are 1016 (3f8) for
Default
Default setting is PENKEY.
Valid settings are
Default setting is 200.
Disabling
APPENDIX A
This is