SECTION 1
" NOTE 1:
SunDisk has been changed to SanDisk.
" NOTE 2:
The 6100 Computer supports SRAM PC Cards natively — meaning, no extra device driv-
ers to load. However, SanDisk cards are not supported through the 6100 BIOS and thus,
need Card and Socket services to be loaded before they can be used.
Sample Configuration Files
Reprogramming Flash Memory
" NOTE:
Always keep the 6100 Computer on charge while performing any setup, reprogramming, or
reflashing.
Updating to Flash Version 1.16 or Later
" NOTE:
If you are updating from an older flash to version, and you have an 8 MB system, you must
format the RAM drive to a size of zero. Otherwise the system may lockup. The only way to
recover from this, once it occurs, is to remove the DRAM board.
DOS Configurations
must
"
"
"
"
Appendix A, Sample Configuration Files.
R
PEN*KEY
6100 Computer Programmer's Reference Guide
Getting Started
1-7