Stand - HP Compaq Pro 4300 Maintenance & Serice Manual

Stand

The stand is secured with three Torx screws. You must remove the center access panel to remove
the stand.
To remove the stand:
1. Prepare the computer for disassembly (see
on page
2. Remove the center access panel (see
3. Remove the three silver Torx screws (1) that secure the stand to the computer.
4. Lift the memory and drive access panel latches (2).
5. Slide the stand toward the top of the computer slightly (3), and then lift the stand off the
computer (4).
Figure 6-41
To replace the stand, reverse the removal procedures.
33).
Removing the stand
Preparing to Disassemble the Computer
Hinge Cover Panel on page 34).
Stand 61